Ford Model A Speedster

Hand-Formed Aluminium Trim Cover

Ford Model A Speedster – Hand-Formed Aluminium Trim Cover

Ford Model A Speedster

Replacing a Damaged One-Off Component with a Hand-Formed Aluminium Original

Not every job that comes through the workshop is a full body. Sometimes a single component has failed, no replacement exists, and the only route forward is to make a new one by hand. This Ford Model A speedster arrived with exactly that problem — a cracked aluminium cover over the steering exit in the bodyside, with no pattern part available anywhere.

Damaged original aluminium cover alongside newly formed oversized replacement before trimming

The Original Component

The existing cover was a compound-curved half-dome in aluminium, flanged at the rim and secured with screws to the bodyside. Age and stress had opened a crack across the crown, and the surrounding metal had distorted enough that a repair would always have shown. On a car finished to this standard, a welded-and-filled patch was never the right answer.

Forming the Replacement

Working from the original as a pattern, we formed a new cover from sheet aluminium, raising the compound curve and shrinking the flange to bring the rim back flat and true. The piece was deliberately left oversized through the forming stages, giving room to work the shape without fighting the edges, then trimmed to final profile once the curvature was correct. Fixing holes were drilled last, taken directly from the car rather than from the old part, so that the new cover sat correctly on its actual mounting points.

Finished and Fitted

Polished to match the surrounding brightwork and screwed into place, the new cover reads as original equipment. Set against the cracked and dulled part it replaced, the difference is not subtle — but on the finished car, it draws no attention at all. That is usually the mark of a job done properly.

Cracked original aluminium pitman arm cover held beside newly hand-formed polished replacement fitted to Ford Model A

Small Parts, Full Skills

A single trim cover is a small piece of work. It still demands the same metal-forming judgement as a full body panel — reading a compound curve, controlling shrink, and making something that fits a car nobody has the drawings for. Where a component needs traditional hand skills rather than a catalogue number, we are glad to take it on.

Owner seated in blue Ford Model A speedster with red wire wheels and whitewall tyres